Chapter 3 PERFORMING MEASUREMENTS
3-12
Changing the Measurement Conditions
Measurement conditions will be retained in the internal memory even if the
instrument is turned OFF. So, when the instrument is turned ON, the measurement
conditions in effect immediately before the instrument was turned OFF previously
will be restored. However, this is not true if the optical module has been changed.
Changing the Wavelength
The wavelength can be changed as explained below.
♦ Example: “SM 1.31µm” → “SM 1.55µm”
1. Locate the cursor to “WAVELENGTH” by using the rotary knob or the arrow
key.
When F3 [MULTI WL MEASURE] is selected “ON”, the cursor can not move on
wavelength.
TIP
Caution
To Next Page
Loading...
Need help?
General
