Chapter 3 PERFORMING MEASUREMENTS
3-88
3.9 Recording the Measured Data [Step 8]
This section explains how to save and print the measured data.
Saving the Measured Data
This section explains how to save the measured data, by taking an example of the
following file name and location.
Save destination drive: PCMCIA
Save destination folder: 2004/Jun/16-30
File type: .SOR(Telcordia)
File name: 003aMeasurement1550nm
If the measured data auto saving function has been set to ON, the measured data
is saved under the various conditions set in this section when an average
measurement is completed.
For the method to enable the automatic saving function, refer to page 3-33.
No
Comment
Wavelength
Caution
Refer
To Next Page
Loading...
