Chapter 1 BEFORE USING THE INSTRUMENT
1-3
1.2 Installation, Storage and Transport
This section explains points to be observed when installing, storing or transporting the
instrument.
Unpacking and Receiving Inspection
Prior to shipment, the instrument has undergone strict mechanical and electrical
inspection to ensure its correct operation. On delivery, immediately unpack and check the
instrument for any damage that might have occurred during transport.
Mechanical Inspection
After the instrument is unpacked, check the appearance, operation of each switch and
connector, and check for any damage or defects that might have occurred during
transport. In addition check that all the accessories are present and correct.
It is recommended that packing materials, such as corrugated boxes and
cushioning materials, be kept in a safe place so that they can be reused when
transporting the instrument again.
Operation Inspection
If no defects are found by mechanical inspection, check the instrument to see whether it
conforms to the specifications.
When Damage or Defects are Found
If damage or non-conformation to the specifications is found during mechanical or
operation inspection, contact the agent from whom the instrument was purchased.
TIP
To Next Page
Loading...
Need help?
General
