Chapter 5 EDITING AUTOMATIC SEARCH RESULTS
5-16
Displaying the List Edit Window
This section explains how to display the window by which the event list can be changed.
1. Measure the optical fiber and perform auto search.
•For the method of measuring an optical fiber and performing auto search, refer to
page 3-56.
•For the screen that shows auto search results at the end of measurement, refer to
page 3-68.
2.
Press [F1] (SCREEN).
A selection window will appear.
*: Indicates the default setting.
3. Locate the cursor to “LIST” by using the rotary knob or [S] / [T].
4. Press [ENTER].
A new screen will appear.
For the new window, refer to page 3-106.
*TRACE + LIST
LIST
Selectable screens
TRACE
TIP
Refer
Refer
To Next Page
Loading...
Need help?
General
