Chapter 7 USING USEFUL FUNCTIONS
7-6
For Traces that Have Not Been Auto Searched
For the window that is displayed just after measurement is finished (without auto
search), refer to page 3-71.
1. Press [MODE] to locate the cursor to “MARKER”.
2. Press [F5] (NEXT PAGE).
3. Press [F5] (AUXILIARY FUNCTION).
4. Press [F3] (APPROX. LINE).
A selection window will appear.
*: Indicates the default setting.
5. Locate the cursor to “DISPLAY” by using the rotary knob or [S] / [T].
6. Press [ENTER].
An approximate line will appear.
No approximate line will appear if no markers have been set.
Refer
Caution
TIP
*NonDISPLAY Hides the approximate line.
Selectable
approximate line setting
DISPLAY Shows the approximate line.
To Next Page
Loading...
Need help?
General
