Chapter 4 ENTERING CHARACTERS
4-9
Adding a Character
This section explains how to add a character by taking an example in which a character is
omitted by mistake from the label.
If the allowed maximum number of characters has already been entered or will be
exceeded by adding new characters, it will not be possible to add them.
1. Display the label input window.
For the method of displaying the label input window, refer to page 4-3.
2. Push the rotary knob to switch the input mode to “INSERT”.
3.
Locate the blink cursor after the character “O” by using the rotary knob.
4. Locate the cursor to “T” by using the arrow key.
"T" is missing.
"AQ7260 ODR"
Current label
"AQ7260 OTDR"
Label to be entered
Refer
Caution
To Next Page
Loading...
