Chapter 1 BEFORE USING THE INSTRUMENT
1-14
Attaching a New Optical Module
This section explains how to attach a new optical module. It is assumed that the optical
module and its cover have been removed.
1. Make sure that the power to the instrument is turned OFF.
WARNING
Do not replace the optical module while the instrument is powered ON.
Failure to observe this may result in electric shock or breakdown.
For the method of turning OFF the power, refer to page 3-107.
2. Connect the optical module’s connector to the one on the optical module.
CAUTION
When attaching the optical module, insert the connector slowly. Never shake the connector
sideways or insert it by force.
Doing so may damage the connector.
Refer
To Next Page
Loading...
Need help?
General
