Chapter 3 PERFORMING MEASUREMENTS
3-53
3.6 Setting the File Name/Location to Store the File
[Step 5]
If the measured data auto saving function of the measurement condition has been
enabled, the acquired data is automatically saved when an average measurement is
completed. So it is necessary to set the file name and to select drive and folder to store
the data, prior to measurement.
•For the method to enable the measured data auto saving function, refer to page
3-33.
•For the method to set the file name, refer to page 3-96, page 3-103.
•For the method to set the location to store the data, refer to page 3-91.
Refer
To Next Page
Loading...
