Chapter 10 APPENDIX
10-2
10.1 Software Upgrade
To support new products or to provide new functions, this instrument allows software
upgrade. The software can be upgraded by the procedure given below.
Software upgrade can be performed using the following storage mediums.
Floppy disk (expansion unit, USB)
USB memory
PCMCIA
1. Make sure that the power to the instrument is turned OFF.
For the method of turning OFF the power, refer to page 3-107.
2. Connect the instrument to an AC power outlet.
Software upgrade can be performed only when the instrument is running with AC
power.
3. Connect a storage medium containing the software to the instrument.
Pleas save the software to root folder in storage media.
For the method of connecting a storage medium, refer to Chapter 8.
Caution
Refer
Caution
Refer
Caution
To Next Page
Loading...
Need help?
General
