Chapter 4 ENTERING CHARACTERS
4-4
Entering a Label
This section explains how to enter the following characters.
♦ Example: AQ7260 OTDR
The label can consist of up to 36 characters.
A label can be entered even when measurement is in progress.
1. Locate the character cursor to “A” by using the arrow key.
2. Press [ENTER].
“A” will be displayed in the [LABEL] field.
3. Locate the character cursor to “Q” by using the arrow key.
4. Press [ENTER].
5. Locate the character cursor to “7” by using the arrow key.
6. Press [ENTER].
7. Locate the character cursor to “2” by using the arrow key.
8. Press [ENTER].
9. Locate the character cursor to “6” by using the arrow key.
Caution
TIP
To Next Page
Loading...
