Chapter 4 ENTERING CHARACTERS
4-7
4.2 Editing Characters
Deleting a Character
This section explains how to delete a character by taking an example in which an
superfluous character is entered by mistake into the label.
1. Display the label input window.
For the method of displaying the label input window, refer to page 4-3.
2. Push the rotary knob to switch the input mode to “INSERT”.
3. Locate the blink cursor after the character “5” to be deleted by turning the
rotary knob.
If the current input mode is “OVERWRITE”, locate the blinking cursor on “5”.
4. Press [F2] (BACK SPACE) to delete the unwanted character (“5”).
5. Press [F5] (DONE) to register the label.
Extra character
"AQ72560 OTDR"
"AQ7260 OTDR"
Current label
Label to be entered
Refer
TIP
To Next Page
Loading...
