Chapter 7 USING USEFUL FUNCTIONS
7-51
Emitting a Laser
1. Connect an optical fiber to the instrument.
2. Press [F1] (LIGHT SOURCE).
A selection window will appear.
*: Indicates the default setting.
3. Locate the cursor to “ON” by using the rotary knob or [S] / [T].
4. Press [ENTER].
A laser will be emitted and “LASER ON” will appear.
WARNING
Do not disconnect the optical fiber from the instrument while laser is emitted , and do not
stare into the end of the connected optical fiber.
Laser beams are invisible to the naked eye, but if they enter the eyes, they may cause
impaired eyesight.
Turn off a Laser
1. Press [F2] (LIGHT SOURCE OFF).
TIP
*OFF
Selectable
light source
ON
To Next Page
Loading...
