Chapter 3 PERFORMING MEASUREMENTS
3-34
3. Locate the cursor to “ON” by using the rotary knob or [S] / [T].
4. Press [ENTER] to register the change made to the auto saving.
5. Press [F4] (DONE) to register the changes made to the measurement
conditions.
If this function has been set to ON, the acquired data is automatically saved. So
make sure to set the saving condition prior to measurement.
When changing the condition for two or more items, it is recommended to change
the condition for each item first and then press [F4].
• For the method to set the saving condition, refer to page 3-88.
• Refer to the notes given on changing the measurement conditions (page 3-50).
Caution
Refer
TIP
To Next Page
Loading...
Need help?
General
