Chapter 3 PERFORMING MEASUREMENTS
3-39
2. Press [ENTER].
A selection window will appear.
*: Indicates the default setting.
3. Locate the cursor to “TPA” by using the rotary knob or [S] / [T].
4. Press [ENTER] to register the change made to the approximate method.
5. Press [F4] (DONE) to register the changes made to the measurement
conditions.
When changing the condition for two or more items, it is recommended to change
the condition for each item first and then press [F4].
Refer to the notes given on changing the measurement conditions (page 3-50).
TIP
Refer
TIP
*LSA
Selectable
approximate methods
TPA
To Next Page
Loading...
