Chapter 7 USING USEFUL FUNCTIONS
7-22
Entering the Fiber Type
1. Locate the cursor to “FIBER TYPE” by using the rotary knob or [S] / [T].
2.
Press [ENTER].
A selection window will appear.
*: Indicates the default setting.
3.
Locate the cursor to the type of currently measured optical fiber by using the
rotary knob or [S] / [T].
4. Press [ENTER] to register the change made to the fiber type.
TIP
*SMF(652) Single mode fiber
DSF(653) Dispersion-shifted fiber
NZ-DSF (655) Non-zero dispersion shifted single mode fiber
Selectable
fiber types
MMF(651) Multi mode fiber
To Next Page
Loading...
