YOKOGAWA GS200 - 13.2 Commands

13.2 Commands
13.2.1 List of Commands
Command Function Page
Output Commands (OUTPut group)
:OUTPut
[:STATe]/?
Sets or queries the output state (on/off). 13-10
Source Commands (SOURce group)
:SOURce
:FUNCtion/?
Sets or queries the source function (voltage/current). 13-11
:RANGe/?
Sets or queries the source range. 13-11
:LEVel
[:FIX]/?
Sets or queries the source level in terms of the range that is being used. 13-11
:AUTO/?
Sets or queries the source level in terms of the most appropriate range. 13-12
:PROTection
:VOLTage/?
Sets or queries the voltage limiter level. 13-12
:CURRent/?
Sets or queries the current limiter level. 13-12
Program Commands (PROGram group)
:PROGram
:REPeat
[:STATe]/?
Sets or queries the program execution repetition mode (on/off). 13-13
:INTerval/?
Sets or queries the program execution timer’s period. 13-13
:SLOPe/?
Sets or queries the program slope time. 13-13
:TRIGger/?
Sets or queries the program trigger. 13-13
:EDIT
:STARt
Starts program memory editing. 13-13
:END
Ends program memory editing. 13-13
:SAVE
Saves the program memory as a program file. 13-13
:LOAD/?
Loads a program file into program memory. 13-13
:DELete
Deletes a program file. 13-14
:DEFine
Creates a program file. 13-14
:MEMory
Writes a program file to program memory. 13-14
:CATalog?
Queries the list of program files. 13-14
:RUN
Executes a program (RUN execution). 13-14
:STEP
Executes a program (STEP execution). 13-14
:HOLD
Pauses and resumes program execution. 13-14
:PAUSe
Pauses program execution. 13-14
:CONTinue
Resumes program execution. 13-14
:COUNt/?
Sets or queries the step that the current program begins execution at. 13-14
Measurement Commands (SENSe group)
:SENSe
[:STATe]/?
Sets or queries the measurement feature (on/off). 13-15
:NPLC/?
Sets or queries the measurement integration time in terms of PLC. 13-15
:DELay/?
Sets or queries the measurement delay time. 13-15
:TRIGger/?
Sets or queries the measurement trigger. 13-15
:INTerval/?
Sets or queries the measurement timer’s period. 13-15
:NULL
[:STATe]/?
Sets or queries the NULL computation feature (on/off). 13-15
:ZERO
:EXECute
Executes measurement zero calibration. 13-16
:REMote/?
Sets or queries the wiring system (on = 4W/off = 2W). 13-16
:GUARd/?
Sets or queries the guard state (on/off). 13-16
13-7
IM GS210-01EN
Communication Commands
3
2
1
4
5
6
7
8
9
10
11
12
13
14
15
App
Index