Measurement Triggers (/MON option; see section 7.4 for the procedure)
This trigger is used to start a measurement operation (see section 2.5). Select any of the
following trigger sources.
• Measurement timer (
Timer)
You
can set the constant period timer to a period from 0.1 seconds to 3600.0 seconds.
The timer is reset when you turn the output on.
• Measurement completion (immediate;
Immed)
The end of one measurement triggers the beginning of the next measurement.
This is
used in situations such as when you need to repeat measurements at high speeds.
• Source change completion (
Ready)
This is generated 10 ms after the source level is changed.
• Communication commands (Comm)
You can use the communication command
"*TRG"
to start measurements.
2.6 Triggering
2-21
IM GS210-01EN
Features
3
2
1
4
5
6
7
8
9
10
11
12
13
14
15
App
Index
To Next Page
Loading...