YOKOGAWA UP35A - Page 263

12-12
IM 05P02D41-01EN
PVEventStatus
PV event status can be output to the contact output. (The setpoints below are I relay
numbers.)
► I relay: UTAdvanced Series Communication Interface (RS-485, Ethernet) User's Manual
Setpoint
Function
PV event
status
PV event
output status
4785 4801 PV event 1
4786 4802 PV event 2
• PV event status: The internal alarm status is turned on when an alarm occurs and
turned off in normal condition
• PV event output status: Contact output status when an alarm occurs (ON in alarm
condition and OFF in normal condition)
TimeEventStatus
Time event status can be output to the contact output. (The setpoints below are I relay
numbers.)
► I relay: UTAdvanced Series Communication Interface (RS-485, Ethernet) User's Manual
PV event status Function
4817 Time event 1
4818 Time event 2
4819 Time event 3
4821 Time event 4
AlarmStatus
The alarm status can be output to the contact output. (The setpoints below are I relay
numbers.)
► Irelay:UTAdvancedSeriesCommunicationInterface(RS-485,Ethernet)User'sManual
Setpoint
Function
Alarm status
Alarm output
status
4321 4353 Alarm 1
4322 4354 Alarm 2
• Alarm status: The internal alarm status is turned on when an alarm occurs and
turned off in normal condition
• Alarm output status: Contact output status when an alarm occurs (ON in alarm
condition and OFF in normal condition)
However,theoutputstatusdependsonthesettingsofenergized/de-energizedofalarm,
latch action, and contact type.
Theaboveassumesthatthecontacttypeisenergized.(Thencontactisturnedonwhen
an event occurs.)
To output the normal alarm to the contact output, assign the alarm output status.
► Alarm action: 11.1 Setting Alarm Type
12.2SettingContactOutputFunction