4-6
IM 05P02D41-01EN
5.
Press the Up orDownarrow key to change the setpoint.
(Change the setpoint using the Up/Down arrow keys to increase and decrease
the value and the Left/Right arrow keys to move between digits.)
6.
Press the SET/ENTER key to register the setpoint (the setpoint stops blinking).
7.
Press the PARAMETER key once to return to the Menu Display. Press the
DISPLAY key once to return to the Operation Display.
This completes the setting procedure.
HowtoCancelParameterSetting
To cancel parameter setting when a parameter is being set (setpoint is blinking), press
the PARAMETER key once.
4.2HowtoSetParameters
To Next Page
Loading...
Need help?
General
