Zebra DS6878 - Page 203

RS-232 Interface 8 - 5
RS-232 Host Parameters (continued)
Selecting the ICL, Fujitsu, Wincor-Nixdorf Mode A, Wincor-Nixdorf Mode B, OPOS terminal enables the
transmission of code ID characters listed in Table 8-3 below. These code ID characters are not programmable
and are separate from the Transmit Code ID feature. The Transmit Code ID feature should not be enabled for
these terminals.
Table 8-3 Terminal Specific Code ID Characters
Code Type ICL Fujitsu
Wincor-
Nixdorf
Mode A
Wincor-Nixdorf
Mode B/
OPOS/JPOS
Olivetti Omron CUTE
UPC-A AA A A A AA
UPC-E EE C C C ENone
EAN-8/JAN-8 FF FF B B B FF None
EAN-13/JAN-13 FF A A A FA
Code 39 C <len> None M M M <len> C <len> 3
Code 39 Full ASCII None None M M None None 3
Codabar N <len> None N N N <len> N <len> None
Code 128 L <len> None K K K <len> L <len> 5
I 2 of 5 I <len> None I I I <len> I <len> 1
Code 93 None None L L L <len> None None
D 2 of 5 H <len> None H H H <len> H <len> 2
GS1-128 L <len> None P P P <len> L <len> 5
MSI None None O O O <len> None None
Bookland EAN FF A A A FNone
Trioptic None None None None None None None
Code 11 None None None None None None None
IATA H<len> None H H H <len> H <len> 2
Code 32 None None None None None None None
GS1 Databar
Variants
None None E E None None None
PDF417 None None Q Q None None 6
Datamatrix None None R R None None 4
QR Codes None None U U None None 7
Aztec/Aztec Rune None None V V None None 8
Micro PDF None None S S None None 6
Maxicode None None T T None None None