Radio Communications 4 - 23
Pairing Modes
When operating with the cradle, two modes of pairing are supported:
•
Locked Pairing Mode - When a cradle is paired (connected) to the digital scanner (or up to three digital
scanners for the CR0078-S and up to seven digital scanners for the CR0078-P in Multipoint-to-Point
mode), any attempt to connect a different digital scanner, by either scanning the PAIR bar code on the
cradle or by inserting it into the cradle with the pairing on contacts feature enabled ( page 4-24), is
rejected. The currently connected digital scanner(s) maintain connection. In this mode, you must set a
Connection Maintenance Interval on page 4-26.
•
Unlocked Pairing Mode - Pair (connect) a new digital scanner to a cradle at any time by either scanning
the PAIR bar code on the cradle or by inserting it into the cradle with the pairing on contacts feature
enabled. This unpairs the previous digital scanner from the cradle (Point-to-Point mode only).
To set the cradle pairing mode, scan the appropriate bar code below.
Lock Override
Lock Override overrides a locked digital scanner base pairing and connects a new digital scanner. In
Multipoint-to-Point mode, this unpairs any disconnected (out of range) digital scanner first, in order to connect
the new digital scanner.
To use Lock Override, scan the bar code below, followed by the pairing bar code on the cradle.
*Unlocked Pairing Mode
Locked Pairing Mode
LockOverride