Zebra DS6878 Product Reference Guide

4 - 24 DS6878 Product Reference Guide
Pairing Methods
There are two pairing methods. The default method allows the digital scanner and cradle to pair (connect)
when the pairing bar code on the cradle is scanned. A second method pairs the digital scanner and cradle
when the digital scanner is inserted in the cradle. To enable this feature, scan Enable Pair On Contacts below.
With this feature enabled it is not necessary to scan the pairing bar code on the cradle. If the pairing is
successful, a low/high connection beep sequence sounds a few seconds after the digital scanner is placed in
the cradle. See Wireless Beeper Definitions on page 4-3 for other beep sequences.
To enable or disable pairing on contacts, scan the appropriate bar code below.
Unpairing
Unpair the digital scanner from the cradle or PC/host to make the cradle available for pairing with another
digital scanner. Scan the bar code below to disconnect the digital scanner from its cradle/PC host.
An unpairing bar code is also included in the DS6878 Quick Reference Guide.
*Enable Pair On Contacts
Disable Pair on Contacts
Unpairing

Zebra DS6878 Specifications

General

Wavelength	655 nm
Scanner type	2D
Yaw reading angle	-60 - 60 °
Decoding standards	1D, 2D, PDF417, PDF417, microPDF417, Composite Codes (CC-A, CC-B, CC-C), U.S. Postnet and Planet, U.K., Japan, Australian, Netherlands KIX code, Royal Mail 4 State Customer, UPU ICS 4 State Postal, USPS 4CB, TL C-39, Aztec (Standard, Inverse), MaxiCode, DataMatrix/ECC 200 (Standard, Inverse), QR Code (Standard, Inverse and Micro)
Tilt reading angle	-360 - 360 °
Input voltage	5 V
Bluetooth	Yes
Dimensions (WxDxH)	69 x 97 x 185 mm
Certification	FCC, RoHS
Product color	Black
International Protection (IP) code	IP43
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	5 - 95 %
Cables included	USB

Weight and Dimensions

Weight	238 g