Site Preparation and Installation 3 - 23
4. Route the antenna leads, with partly-stripped ends, as pictured in
Figure 3-26 hanging several inches below
the MP70XX so that the Checkpoint controller lead wires can tie into the antenna.
Figure 3-26 Antenna Leads for Checkpoint Controller Connection
5. Replace the platter.
A cable with two additional leads is available to support Interlock features. The Interlock cable assembly part
number is CB000002A01, ordered as CBA-A54-S01EAR (includes a connector, and a pigtail for Checkpoint).
Contact your local Checkpoint representative to install the EAS cable to the Checkpoint System. Refer to the
Checkpoint device documentation for details about its functionality.
Vertical Checkpoint Antenna
The vertical Checkpoint antenna kit, p/n MX307-SA00WW, includes the following parts.
• Checkpoint antenna
• Left bracket
• Right bracket
• Wire connector
• 2 #6-19 HI-LO 0.5" long screws with T8 torx head.
To install the antenna:
1. Remove the MP70XX platter (see
Figure 5-8 on page 5-6).
2. Ensure the right side bracket is pre-attached to the wire as shown in
Figure 3-27.
To Next Page
Loading...