Zebra MP7000 - RS-232 Terminal Specific Code ID Characters

Host Interfaces and Cable Pinouts 2 - 19
RS-232 Terminal Specific Code ID Characters
Selecting ICL, Fujitsu, Wincor-Nixdorf Mode A, Wincor-Nixdorf Mode B, OPOS/JPOS, Olivetti, Omron, Common
Use Terminal Equipment (CUTE-LP/LG barcode readers), NCR, or Datalogic enables the transmission of code ID
characters listed in
Table 2-7 and Table 2-8. These code ID characters are not programmable and are separate
from the Transmit Code ID feature. Do not enable the Transmit Code ID feature for these terminals.
Table 2-7 Terminal Specific Code ID Characters
Code Type ICL Fujitsu
Wincor-Nixdorf
Mode A
Wincor-Nixdorf
Mode B/
OPOS/JPOS
UPC-A AAA A
UPC-E EEC C
EAN-8/JAN-8 FF FF B B
EAN-13/JAN-13 FFA A
Bookland EAN FFA A
Code 39 C <len> None M M
Code 39 Full ASCII None None M M
Trioptic None None None None
Code 32 None None None None
Codabar N <len> None N N
Code 128 L <len> None K K
GS1-128 L <len> None P P
Code 93 None None L L
I 2 of 5 I <len> None I I
D 2 of 5 H <len> None H H
MSI None None O O
IATA H<len> None H H
GS1 Databar Variants None None E E
PDF417 None None Q Q
MicroPDF417 None None S S
Data Matrix None None R R
QR Codes None None U U
Aztec/Aztec Rune None None V V
* 2D barcodes are not supported.