Zebra MP7000 - Chapter 4: Scale Calibration (For Models With a Scale)

CHAPTER 4 SCALE CALIBRATION
(FOR MODELS WITH A
SCALE)
Introduction
This chapter describes how to calibrate the scale in the MP70XX, and how to program its features.
The parameter barcodes included in this chapter are listed in
Table 4-1.
NOTE All scanner programming barcodes and additional scale parameter barcodes are located in the MP7000
Scanner Scale Barcode Programming Guide (p/n MN-002912-xx).
Table 4-1 Scale Parameters in this Chapter
Parameter
Parameter
Number
Parameter Name
Page
Number
Legal Scale Units 995
Kilograms (default) 4-13
Pounds 4-14
Scale Display Configuration 986
Disable Scale Display (default) 4-16
Enable Scale Display 4-15
Legal Scale Dampening Filter 996
Higher Vibration Sensitivity
4-17
Low Vibration Sensitivity (default) 4-18
Very Low Vibration Sensitivity 4-19
Ultra Low Vibration Sensitivity 4-20
Scale Pole Display Type 1692 Standard Pole Display Type (default) 4-21
Alternate Pole Display Type 4-22