Zebra MP7000 - Remove Existing Scanner Scale and Accessories; Unpacking MP7000 Scanner Scale Equipment

3 - 6 MP7000 Scanner Scale Integrator Guide
Remove Existing Scanner Scale and Accessories
If you are replacing existing equipment, follow these step to remove the old unit:
1. Ensure the POS is logged off, and the drawer was cleared by the store personnel. This varies by location.
Some IT Departments may require the POS to be completely shut down.
2. Unplug the current bioptic scanner from its power supply.
3. Prior to removing cables, make a note of the current cable runs.
4. Remove all cables connected to the bioptic
scanner. Do not cut cables if you are using, or selling the old
equipment.
5. If applicable, unplug the current hand-held device from its power supply, and disconnect it from the current
bioptic scanner/host.
a. If reusing the hand-held device, leave its cable runs intact.
b. If the hand-held device was attached to the bioptic scanner with an RS-232 cable, a new cable and a new
hand-held device configuration is required.
6. If a Sensormatic connection is present, there are two cables to be aware of:
a. The large cable to the coils/antennas - disconnect from the current bioptic but leave in place.
b. The RS-232 cable to the Sensormatic controller communications port - use its run to assist replacing it.
7. If a Scale Display is present:
a. Make a note of how the current display was mounted and determine if the current placement can
accommodate the new Scale Display. Adjustments to the layout, and cable run may be required.
b. Unplug the old Scale Display power.
c. Remove it from the checkstand.
d. Remove its cables.
e. Remove the Scale Display.
8. Remove the existing bioptic scanner.
Unpacking MP7000 Scanner Scale Equipment
To unpack equipment:
1. Remove all components from their packaging, and check that all parts are present. Each box includes the
material listed in
Table 3-1. Each of the items listed is contained in separate packaging within the box and is
recognizable as a discrete item. Power cables, host to scanner communications cables, and trim filler kit are all
sold separately in kits.
Table 3-1 MP7000 Scanner Scale Box Contents
Description Part Number
MP70XX w/o Platter MP70XX-XXXXM00XX
Platter Part number not applicable.
Leveling Screws MX301-SR00004ZZWR. (Leveling screws are included in all
short and medium units.)
Regulatory Guide MN-002939-xx
NOTE An optional Scale Display, is available separately for scale models only.