3 - 22 MP7000 Scanner Scale Integrator Guide
Install the Checkpoint Antennas
There are two Checkpoint EAS antennas available. They can each be used separately or together for better range.
• The horizontal Checkpoint antenna should be set into place in the middle housing of the MP70XX, under the
platter, and the antenna leads for controller connection should be placed as shown in
Figure 3-26. (See page
1-8
for cable routing.)
• The vertical Checkpoint antenna loops around the top of the vertical window (see
page 3-23).
Horizontal Checkpoint Antenna
The horizontal Checkpoint antenna kit, p/n MX306-SA00WW, includes the following parts.
• Horizontal Checkpoint antenna
• 3 #4-24 HI-LO .375" long screws with a T8 torx head.
To install the antenna:
1. Remove the MP70XX platter.
2. Set the antenna into place in the middle housing of the MP70XX, under the platter.
Figure 3-24 Set Antenna in Place
3. Screw the antenna to the housing using a T8 Torx screwdriver (not provided).
Figure 3-25 Secure Antenna to Housing
WARNING! ! If the checkpoint antennas are not installed correctly they can cause issues with scale
functionality.
To Next Page
Loading...