2 - 56 MP7000 Scanner Scale Integrator Guide
AUX A-B (Stacked USB)
POS
NOTE An additional USB port is available in the front under the platter. All USB ports can be used for the
USB staging flash drive. See
Table 1-3 on page 1-13 and USB Staging Flash Drive on page 5-10
for additional information.
Table 2-14 Stacked USB Port
Pin # Signal/Name Direction Description
15V Out
USB 5V output *
2 D- Bidirectional USB D-
3 D+ Bidirectional USB D+
4 GND N/A Signal ground
*The total combined current for the USB and RS-232 peripheral ports should be less than 750mA total auxiliary
current. Each individual port should not exceed 500mA.
Table 2-15 RJ-45, Primary POS
Pin # Signal/Name Direction Description
1 DETECT Out USB cable detect output
2 5V In USB cable 5V detect input
3 GND N/A Signal ground
4 TXD/IBM-A Bidirectional Multiplexed serial TXD/IBM-A
5 RXD/D+ Bidirectional Multiplexed serial RXD/USB D+
6 RTS/IBM-B Bidirectional Multiplexed serial RTS/IBM-B
7 CTS/USB D- Bidirectional Multiplexed serial CTS/USB D
8 DOWNLOAD In POS download
9 N/C N/A No connection
10 12V In Terminal 12VDC to MP70XX
(Power From Terminal)
*
*Terminal systems vary in power capabilities. Ensure your system power supply is capable of the MP70XX
configuration power requirements. For terminals unable to support P.O.T., a 12V DC barrel jack is available for
external power.
To Next Page
Loading...
