Site Preparation and Installation 3 - 11
Install the MX101
The MX101 is an optional modular unit in the MP70XX tower cover that is used for customer side scanning.
Figure 3-7 Customer Side Scanning
Install the MP7000 Scanner Scale
Ensure all components of the MP70XX/scale (if applicable) and cables are ready to install (see
Unpacking MP7000
Scanner Scale Equipment on page 3-6).
Checkstand Counter Cutouts and MP70XX Dimensions
There are three different sets of dimensions for counter cutouts, based on the MP70XX model to install.
After
cutting the edges they should be clean and straight, with all burrs and splinters removed.
The MP70XX is 11.5 in. wide. If replacing a pre-existing scanner in a checkstand that is 12 in. wide, we recommend
a Trim Filler Kit to fill-in the gap in the checkstand (see
Trim Kit Installation (If Required) on page 3-29).
The MP70XX is 4 in. deep. If replacing a pre-existing 5 in. deep short or medium scanner, you must use the 1 in.
longer leveling screw kit (p/n MX302-SR00004ZZWR). This will bring the platter up to the countertop level.
NOTE For detailed information about the Customer Side Scanner, refer to the MX101 Customer Side
Scanner for the MP7000 Scanner Scale (p/n MN-003031-xx).
To Next Page
Loading...