vi MP7000 Scanner Scale Integrator Guide
•
Chapter 3, Site Preparation and Installation describes how to install the MP7000 Scanner Scale into a
counter top.
•
Chapter 4, Scale Calibration (For Models With a Scale) describes how to change weight measurement,
calibrate the scale, verify calibration, and recognize errors.
•
Chapter 5, Operating the Scanner describes how to operate the MP7000 Scanner Scale including buttons,
switches, LED indicators, and scanning.
•
Chapter 6, 123Scan and Software Tools provides information about configuring the MP7000 Scanner Scale
using the 123Scan
utility.
•
Appendix A, Maintenance, Troubleshooting, and Error Codes provides error/warning codes, troubleshooting,
and maintenance information.
•
Appendix B, Technical Specifications provides technical information about the MP7000 Scanner Scale.
•
Appendix C, ASCII Character Sets provides ASCII character sets for some host interfaces.
•
Appendix D, Standard Parameter Defaults provides a list of defaults for the parameters in this guide. For all
MP7000 Scanner Scale programming barcodes, refer to the MP7000 Scanner Scale Barcode Programming
Guide (p/n MN-002912-xx).
•
Appendix E, Communication Protocol Functionality provides a table of MP7000 Scanner Scale
communication interfaces.
•
Appendix F, Statistics provides a table of MP7000 Scanner Scale attribute statistics.
Notational Conventions
The following conventions are used in this document:
•
Italics are used to highlight the following:
• Chapters and sections in this guide
• Related documents
•
Bold text is used to highlight the following:
• Dialog box, window and screen names
• Drop-down list and list box names
• Check box and radio button names
• Icons on a screen
• Key names on a keypad
• Button names on a screen.
•
Bullets (•) indicate:
• Action items
• Lists of alternatives
• Lists of required steps that are not necessarily sequential.
•
Sequential lists (e.g., those that describe step-by-step procedures) appear as numbered lists.
To Next Page
Loading...