Zebra MP7000 - Page 43

Host Interfaces and Cable Pinouts 2 - 13
Table 2-2 Host Connections
Port Connection Options
POS Standard USB
(p/n
CBA-U51-S16ZAR)
USB PlusPower
(p/n
CBA-U52-S16PAR)
RS-232
(p/n
CBA-R51-S16ZAR)
RS-485
(p/n CBA-M51-S16PAR)
Table 2-3 Auxiliary Connections
Configuration
Choices for the
Devices Below
RS-232
Device Port
Configuration
Value
(see parameter
1246
page 2-33)
Connect Device to These Ports
AUX 1 AUX 2 USB2 USB3
RS-232 auxiliary scanner,
and a Sensormatic
Controller
3
0
1
Sensormatic
Controller
RS-232 auxiliary
scanner
3
USB auxiliary
scanner
3
USB auxiliary
scanner
3
RS-232 auxiliary scanner,
and a Dual Cable
Scanner/Scale
3
1 Dual Cable
Scanner/Scale
2
RS-232 auxiliary
scanner
3
USB auxiliary
scanner
3
USB auxiliary
scanner
3
Dual Cable Scanner/Scale,
and a Sensormatic
Controller
3
2 Sensormatic
Controller
Dual Cable
Scanner/Scale
2
USB auxiliary
scanner
3
USB auxiliary
scanner
3
Third-Party-Scale &
Sensormatic-Controller
4 Third-Party-Scale Sensormatic
Controller
USB auxiliary
scanner
3
USB auxiliary
scanner
3
1
Default setting
2
The Dual Cable Scanner/Scale supports the industry standard SASI, DIGI, ICL OMRON, ICL Old OMRON,
ICL Portugal, scale-only protocols. The default protocol on this Dual Cable Scanner/Scale port is SASI.
3
In all configurations up to one or two additional USB auxiliary scanners can be connected, but the total RS-232
auxiliary scanners plus USB auxiliary scanners cannot exceed two. An auxiliary scanner is not counted until it
is attached.