GDP-32II INSTRUCTION MANUAL
May 2002 Section 2, Page 16
To turn OFF the GDP-32
II
:
Press to return to the Main menu.
Press
to access the Utilities menu.
Press
– Turn Power Off
The display now shows:
Press CONTINUE to turn off power.
Any other key to return to Main Menu.
Press
Enter
. Wait for the receiver to shut down all of the analog cards and the
Zonge logo is displayed.
Press and hold
ON/OFF
until the screen goes blank and you hear a series of single
“beeps”. See Section 3.3.
Press the POWER ON/OFF button on the Control I/O side panel. The Crystal
Oscillator power light will turn off.
NOTE – Turning the receiver completely off causes the synchronization between the
receiver and the transmitter controller to be lost.
3. PARALLEL
The bi-directional parallel port is used to transfer data from the LCD screen to a printer,
or from the hard disk to a computer, printer, or other output device.
4. SERIAL
The RS-232C serial port is used to output data to a computer, or to input calibration data.
This connector is compatible with a standard IBM-PC compatible COM port. (Default
transfer values are: 9600 baud, no parity, 8 data bits, 1 stop bit.)
5. GPS OPTION
Optional equipment on the GDP-32
II
, an internal GPS receiver.
6. BATTERY CHARGE
The Battery Charge port connects the GDP-32
II
to a battery charger or to an external 12-
volt DC power supply.
To Next Page
Loading...
