NATURAL SOURCE MAGNETOTELLURICS
Section 13, Page 31 May 2002
HAVING ACQUIRED DATA,
WAITING FOR STOP TIME:
Here we have acquired the specified
number of stacks in the very high
frequency band, as specified in the time
schedule. The operator can continue to
acquire data on a single frequency band
basis (one stack at a time) until the stop
time occurs, and data acquisition in the
next frequency band begins.
Also, while the "Waiting for starting time"
or Waiting for stop time" messages are
displayed, the
key is active. The
operator can exit the data acquisition
routine and check the data cache, plot data,
etc. When the operator exits the data
mode, the time schedule operation will take
over.
Data acquisition for the next frequency
band is complete - waiting for the stop time
and the next frequency band change.
0146 AMT 0538 12.3 15 Mar 98 09:46:42
Survey Tensor AMT Stop Time 09:47:00
Tx 1 Rx 1 N OUT
384-8192 10/ 10 Stacks
CH Sta/Ant MAG CC/
φ
φφ
φ
rho GGGA
1Ex 1347.46u 0.540108.7000O
2Hy 147.9696u3126.8 0000O
3Ey 1382.29u 0.52367.56000O
4Hx 247.7244u 115.3 0000O
5OFF
6OFF
7OFF
8OFF
aiting for stop time 09:47:00
0115 AMT 0538 12.3 15 Mar 98 09:50:32
Survey Tensor AMT Stop Time 09:51:00
Tx 1 Rx 1 N OUT
48-1024 10/ 10 Stacks
CH Sta/Ant MAG CC/
φ
φφ
φ
rho GGGA
1Ex 1727.46u 0.620112.3000O
2Hy 1415.696u3111.8 0000O
3Ey 1764.21u 0.02372.12000O
4Hx 2414.994u 115.3 0000O
5OFF
6OFF
7OFF
8OFF
aiting for stop time 09:51:00
To Next Page
Loading...
