MAINTENANCE
Section 17, Page 3 May 2002
Figure 17.2 (a) - Diagnostic Screen
displaying default values on cold startup.
Figure 17.2 (b) - Diagnostic after turning
on channel 1. The A/D Output Line is
blank until an analog channel is turned on.
DIAG 5.0 13 Mar 96 17:00:00
Freq 1 Hz Ch 1 SN 177
SR 1024 Hz Power OFF Notch 50,3-5,9
DUTY 100% DiffAmp
Xmitter ON Cal IN
Ohm OUT
Cal Pow OFF At ten IN
Mux Pow OHM DA C 0 .000V
DAC 0 Notch OUT
.000 V G ains 1 1 1
Mux Cal Alias OUT LO Value 0
Output OHM Mux ANALOG
+100uA
Escape to exit, CONTINUE f or measurement
PREV NEXT ACAL
DIAG 5.0 13 Mar 96 17:00:00
Freq 1 Hz Ch 1 SN 177
SR 1024 Hz Power ON Notch 50,3-5,9
DUTY 100% DiffAmp
Xmitter ON Cal OUT
Ohm OUT
Cal Pow OFF At ten OUT
Mux Pow OHM DA C 0 .000V
DAC 0 Notch OUT
.000 V G ains 1 1 1
Mux Cal Alias OUT LO Value 128
Output OHM Mux ANALOG
+100uA 0.00246819V18
Escape to exit, CONTINUE f or measurement
PREV NEXT ACAL
To Next Page
Loading...
