IEC04000155 V2 EN
Figure 542: Antenna with console
where:
1 GPS antenna
2 TNC connector
3 Console, (2'6.7"x4'11')
4 Mounting holes about 1/5"
5 Tab for securing of antenna cable
6 Vertical mounting position
7 Horizontal mounting position
Antenna cable
Use a 50 ohm coaxial cable with a male TNC connector in the antenna end and a male
SMA connector in the receiver end to connect the antenna to GTM. Choose cable type
and length so that the total attenuation is max. 26 dB at 1.6 GHz.
Make sure that the antenna cable is not charged when connected to the
antenna or to the receiver. Short-circuit the end of the antenna cable
with some metal device, when first connected to the antenna. When the
1MRK505222-UUS C Section 19
IED hardware
1131
Technical reference manual
To Next Page
Loading...
