ABB Relion 670 series - Setting parameters; Reservation input RESIN; Introduction; Principle of operation

12.3.9.5 Setting parameters
Table 346: QCRSV Non group settings (basic)
Name Values (Range) Unit Step Default Description
tCancelRes 0.000 - 60.000 s 0.001 10.000 Supervision time for canceling the reservation
ParamRequest1 Other bays res.
Only own bay res.
- - Only own bay res. Reservation of the own bay only, at selection
of apparatus 1
ParamRequest2 Other bays res.
Only own bay res.
- - Only own bay res. Reservation of the own bay only, at selection
of apparatus 2
ParamRequest3 Other bays res.
Only own bay res.
- - Only own bay res. Reservation of the own bay only, at selection
of apparatus 3
ParamRequest4 Other bays res.
Only own bay res.
- - Only own bay res. Reservation of the own bay only, at selection
of apparatus 4
ParamRequest5 Other bays res.
Only own bay res.
- - Only own bay res. Reservation of the own bay only, at selection
of apparatus 5
ParamRequest6 Other bays res.
Only own bay res.
- - Only own bay res. Reservation of the own bay only, at selection
of apparatus 6
ParamRequest7 Other bays res.
Only own bay res.
- - Only own bay res. Reservation of the own bay only, at selection
of apparatus 7
ParamRequest8 Other bays res.
Only own bay res.
- - Only own bay res. Reservation of the own bay only, at selection
of apparatus 8
12.3.10 Reservation input RESIN
12.3.10.1 Introduction
The Reservation input (RESIN) function receives the reservation information from
other bays. The number of instances is the same as the number of involved bays (up to
60 instances are available).
12.3.10.2 Principle of operation
The reservation input (RESIN) function is based purely on Boolean logic conditions.
The logic diagram in figure
349 shows how the output signals are created. The inputs
of the function block are connected to a receive function block representing signals
transferred over the station bus from another bay.
Section 12 1MRK505222-UUS C
Control
686
Technical reference manual