ABB Relion 670 series - Setting parameters; Integer to Boolean 16 conversion with logic node representation IB16 FCVB; Introduction; Operation principle

Name Type Description
OUT14 BOOLEAN Output 14
OUT15 BOOLEAN Output 15
OUT16 BOOLEAN Output 16
14.7.5 Setting parameters
The function does not have any parameters available in the local HMI or PCM600.
14.8 Integer to Boolean 16 conversion with logic node
representation IB16FCVB
Function description IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
Integer to boolean 16 conversion with
logic node representation
IB16FCVB - -
14.8.1 Introduction
Integer to boolean conversion with logic node representation function (IB16FCVB) is
used to transform an integer to 16 binary (logic) signals.
IB16FCVB function can receive remote values over IEC61850 depending on the
operator position input (PSTO).
14.8.2 Operation principle
With integer 15 on the input INP the OUT1 = OUT2 = OUT3= OUT4 =1 and the
remaining OUTx = 0 for (5≤x≤16).
OUTx represents a value when activated. The value of each of the OUTx is in
accordance with the table ITBGAPC_1. When not activated the OUTx has the value 0.
In the above example when integer 15 is on the input INP the OUT1 has a value =1,
OUT2 has a value =2, OUT3 has a value =4 and OUT4 has a value =8. The sum of
these OUTx is equal to 1 + 2 + 4 + 8 = 15.
This follows the general formulae: The sum of the values of all OUTx = 2
x-1
where
1≤x≤16 will be equal to the integer value on the input INP.
1MRK505222-UUS C Section 14
Logic
891
Technical reference manual