19.4.2 19” panel rack mounting
19.4.2.1 Overview
All IED sizes can be mounted in a standard 19” cubicle rack by using the for each size
suited mounting kit which consists of two mounting angles and fastening screws for
the angles.
The mounting angles are reversible which enables mounting of IED size 1/2 x 19” or
3/4 x 19” either to the left or right side of the cubicle.
Please note that the separately ordered rack mounting kit for side-by-
side mounted IEDs, or IEDs together with RHGS cases, is to be
selected so that the total size equals 19”.
When mounting the mounting angles, be sure to use screws that follows
the recommended dimensions. Using screws with other dimensions
than the original may damage the PCBs inside the IED.
Section 19 1MRK505222-UUS C
IED hardware
1146
Technical reference manual
To Next Page
Loading...
