ABB Relion 670 series - Mounting procedure for side-by-side flush mounting

When mounting the plates and the angles on the IED, be sure to use
screws that follows the recommended dimensions. Using screws with
other dimensions than the original may damage the PCBs inside the IED.
Please contact factory for special add on plates for mounting FT
switches on the side (for 1/2 19" case) or bottom of the relay.
19.4.5.2 Mounting procedure for side-by-side flush mounting
xx06000181.vsd
1
2
3
4
IEC06000181 V1 EN
Figure 562: Side-by-side flush mounting details (RHGS6 side-by-side with 1/2 x 19”
IED).
PosNo
Description Quantity Type
1 Mounting plate 2 -
2, 3 Screw 16 M4x6
4 Mounting angle 2 -
Section 19 1MRK505222-UUS C
IED hardware
1152
Technical reference manual