ABB Relion 670 series - Page 972

Name Values (Range) Unit Step Default Description
OverTrigLe38 0 - 5000 % 1 200 Over trigger level for analog cha 38 in % of
signal
Operation39 Disabled
Enabled
- - Disabled Operation On/off
NomValue39 0.0 - 999999.9 - 0.1 0.0 Nominal value for analog channel 39
UnderTrigOp39 Disabled
Enabled
- - Disabled Use under level trig for analog cha 39 (on) or
not (off)
UnderTrigLe39 0 - 200 % 1 50 Under trigger level for analog cha 39 in % of
signal
OverTrigOp39 Disabled
Enabled
- - Disabled Use over level trig for analog cha 39 (on) or
not (off)
OverTrigLe39 0 - 5000 % 1 200 Over trigger level for analog cha 39 in % of
signal
Operation40 Disabled
Enabled
- - Disabled Operation On/off
NomValue40 0.0 - 999999.9 - 0.1 0.0 Nominal value for analog channel 40
UnderTrigOp40 Disabled
Enabled
- - Disabled Use under level trig for analog cha 40 (on) or
not (off)
UnderTrigLe40 0 - 200 % 1 50 Under trigger level for analog cha 40 in % of
signal
OverTrigOp40 Disabled
Enabled
- - Disabled Use over level trig for analog cha 40 (on) or
not (off)
OverTrigLe40 0 - 5000 % 1 200 Over trigger level for analog cha 40 in % of
signal
Table 595: B1RBDR Non group settings (basic)
Name
Values (Range) Unit Step Default Description
Operation01 Disabled
Enabled
- - Disabled Trigger operation On/Off
TrigLevel01 Trig on 0
Trig on 1
- - Trig on 1 Trig on positiv (1) or negative (0) slope for
binary inp 1
IndicationMa01 Hide
Show
- - Hide Indication mask for binary channel 1
SetLED01 Disabled
Enabled
- - Disabled Set red-LED on HMI for binary channel 1
Operation02 Disabled
Enabled
- - Disabled Trigger operation On/Off
TrigLevel02 Trig on 0
Trig on 1
- - Trig on 1 Trig on positiv (1) or negative (0) slope for
binary inp 2
IndicationMa02 Hide
Show
- - Hide Indication mask for binary channel 2
SetLED02 Disabled
Enabled
- - Disabled Set red-LED on HMI for binary channel 2
Table continues on next page
Section 15 1MRK505222-UUS C
Monitoring
966
Technical reference manual