Reviewing and Selecting Rerun and Replicate Results
AEROSET
®
Customer Training Guide 5-29
94858-103 — July 2003
Selecting the Rerun or Replicate Result to Report
Once a sample rerun is complete, the Operator has the option to select
the rerun result or accept the original result. The original result can be
accepted by following the Accepting Results Procedure described in this
Module. To select a rerun or replicate result to report, perform the
following procedure:
1. Display the desired rerun or replicate result, using the procedure
described in the preceding section.
2. Highlight the assay for which the rerun result will be accepted.
NOTE: To select all rerun results for a sample, press [O]
or [o] (not case sensitive) on the keyboard.
3. Select <Select> in the right-hand column of the RESULT screen (or
press [S] on the keyboard).
CAUTION: Once a rerun or replicate result is selected,
the original result is no longer accessible.
4. An “S” displays to the left of the assay name, and the rerun or
replicate result is copied over the original result for this assay.
5. Select <OK> to exit the RESULT screen.
6. A request to validate all results is displayed.
7. If all results for the sample are acceptable, select <OK>.
8. If results need to be validated later, select <Cancel>.
• With 1.02ER000 software, an
operator can replace original/
first replicate results with rerun
or replicate results displayed
on the RESULT screen at once
by pressing [O] key on the
keyboard. Select <OK> twice to
complete the action.
!
To Next Page
Loading...