Weekly Maintenance
AEROSET
®
Customer Training Guide 10-7
94858-103 — July 2003
Weekly Maintenance Activity
Introduction
In this exercise, you will perform the Weekly Maintenance Procedures.
Objective
Upon completion of the Weekly Maintenance Activity, you will be
familiar with:
• Cleaning the Outside of the Sample and Reagent Probes
• Cleaning the Mixers
• Cleaning the Touchscreen Display
• Checking the ICT™ Probe and Tubing
• Check Sample and Reagent Probes
• Check Tubing from the High-Concentration Waste Drain Hose and
High-Concentration Waste Pump Output T-fitting
Necessary Materials
• AEROSET System Operations Manual
NOTE: The materials required for each procedure are
defined in the AEROSET System Operations Manual.
Procedure
The information for the following steps is found in the AEROSET
System Operations Manual.
Refer to Weekly Maintenance in Section 9, Service and Maintenance of
the AEROSET System Operations Manual to perform the following
procedures:
1. Clean the outside of the Sample and Reagent Probes.
2. Clean the Mixers.
3. Clean the Touchscreen Display.
4. Check the ICT Probe and Tubing.
5. Check sample and reagent probes for damage and protein buildup
6. Check tubing from the High-Concentration Waste Drain Hose and
High-Concentration Waste Pump Output T-fitting.
Instructor will need the
following for demo:
-1% Alk Wash
- Cotton swabs
-DI water
- Alcohol
-Kay Dry
To Next Page
Loading...