Abbott Diagnostics Aeroset - Review Questions

MODULE 10: MAINTENANCE
10-22 AEROSET
®
Customer Training Guide
94858-103 — July 2003
REVIEW QUESTIONS
1. What solution is used to clean the Sample and Reagent Probes
during Weekly Maintenance?
2. What solution is used to clean the Mixers during Weekly
Maintenance?
3. When observing the Wash ICT™ with IRef Procedure what should
not be seen?
4. Why is it necessary to remove the Reagent Supply Center
segments in a specific order?
5. Why are the Sample and Calibrator/Control Carousels cleaned
monthly with a 10% bleach solution?
6. To remove the cover from the ___________ Arm, you must access
the MAINTENANCE UTILITIES screen to move it over the
cuvette dispensing position.
7. Abbott recommends performing System Backup Procedures after:
a. _____________________________________________
b. _____________________________________________
c. _____________________________________________
d. _____________________________________________
e. _____________________________________________
f. ________________________________________________
8. What type of disk must be used for a System Backup option?