Objectives
AEROSET
®
Customer Training Guide 11-3
94858-103 — July 2003
MODULE 11: COMPONENT REPLACEMENT AND TROUBLESHOOTING
OBJECTIVES
Upon completion of this Module, you will be able to:
1. Identify the different Error Log Messages and Codes that are
displayed by the AEROSET System
2. Demonstrate the correct Power OFF Procedure
3. Identify and use the various pages of the MAINTENANCE
UTILITIES screen to:
• Set the System date and time
• Check temperatures
• Track component usage
• Control robotic movements
• Check photometer performance
• Verify cuvette integrity
• Verify Bar Code Reader performance
4. Successfully remove and replace the following components:
• Sample Probes and tubing
• Reagent Probes and tubing
• Cuvette Washer Dryer Tips
•Mixer
• Cuvette Segment
• Cuvette pair
• Sample Carousel Tube Bottom Holder
• Source lamp
To Next Page
Loading...