Print Options
AEROSET
®
Customer Training Guide 8-19
94858-103 — July 2003
PRINT OPTIONS
Printer Configuration
Printer A should be designated to print Form 1, and Printer B used to
print Form 2.
The following options are available for Printer A and Printer B
configuration:
*This option is available for Printer A configuration only.
To configure Printer A and B:
• Select or in the Action Area.
•Select <Config>.
For information about configuration of Printer A and Printer B, refer to
Printer Icons in Section 2, Installation Procedures and Special
Requirements of the AEROSET System Operations Manual.
Option Description
Result Printing
Mode
Three options are available:
• Request: Reports only print manually by request.
• Valid: Reports print automatically when all results are
validated.
• All: Reports print automatically when the results are
completed. The Default for Printer A is All and Printer
B is Request.
Wait Time for
Multi-Print Feature
(sec)
This option is not used for the default report forms
configured in the System.
Enable Calibration
Reports*
When selected, this form prints automatically according
to the Result Printing Mode.
Enable Control
Reports
When selected, this form prints automatically according
to the Result Printing Mode.
Enable Patient
Reports
When selected, this form prints automatically according
to the Result Printing Mode.
NOTE:
If... Then
Enable Control Reports is selected
for Printer B (Form 2)
and the Reference Ranges option
on the PAGE SETUP screen is
selected for Form 2
Reference ranges printed
on the report are patient
reference ranges, not QC
ranges.
• Pass out copies of Report
Forms.
•1
st
option asks to clear printer
buffer (select config).
• The Multi-Print options are
selected on the Database
screen. (Print/Page Setup)
To Next Page
Loading...