Abbott Diagnostics Aeroset - Quarterly Maintenance Activity

MODULE 10: MAINTENANCE
10-12 AEROSET
®
Customer Training Guide
94858-103 — July 2003
Quarterly Maintenance Activity
Introduction
In this exercise, you will perform the Quarterly Maintenance Procedures.
Objective
Upon completion of the Quarterly Maintenance Activity, you will be
familiar with:
• Replacing the Syringe Seal Tip and O-Ring on sample, reagent, and
wash solution syringes
• Replacing the 1 mL wash solution syringes
• Replacing the 1 mL ICT™ reference solution syringe
• Replacing the 1 mL ICT aspiration syringe
• 0.22 Micron Filter replacement (if applicable)
Necessary Materials
• AEROSET System Operations Manual
NOTE: The materials for each procedure are defined in
the AEROSET System Operations Manual.
Procedure
The information for the following steps is found in the AEROSET
System Operations Manual.
Refer to Component Replacement in Section 9, Service and
Maintenance of the AEROSET System Operations Manual to
perform the following procedures:
1. Syringe Seal Tip and O-Ring replacement on sample, reagent, and
wash solution syringes
2. 1 mL Wash Solution Syringe replacement
3. 1 mL ICT Reference Solution Syringe replacement
4. 1 mL ICT Aspiration Syringe replacement
5. 0.22 Micron Filter replacement (if applicable)
Instructor will need the
following for demo:
- Flathead screwdriver
- Phillips screwdriver
- 7mm wrench
- absorbant towels
-cotton swabs