MODULE 2: BASIC RUN
2-18 AEROSET
®
Customer Training Guide
94858-103 — July 2003
Procedure:
1. Determine the appropriate line for creatinine.
2. Determine if any adaptors are needed for this reagent.
3. Load the R1 reagent on the appropriate line in any empty reagent
position in the R1 reagent carousel.
4. Load the R2 reagent on the appropriate line in any empty reagent
position in the R2 reagent carousel.
5. Repeat steps one through four for the following reagents:
• Total Protein
•ALT
•Glucose
• Albumin P
6. After completion of loading above reagents, select <RGT SCAN>
in the action area of the screen.
7. Select <OK> to start reagent scan.
8. After reagent scan is complete, select <Assays> in the information
access area.
9. Ensure that the text for the first 14 assays is not black.
10. Select <Reagents> in the information access area.
11. Review Reagents screens, including Reagent View and Reagent
Supply Center Tabs.
• Advise customer to check all
Reagent Supply Center Tabs.
To Next Page
Loading...