Advantech EKI-7710E-2C - Snmp; Figure 4.86 Management > LLDP > LLDP Overloading; Figure 4.87 Management > SNMP > SNMP Settings

EKI-7710 Series User Manual 93
4.9.1.5 LLDP Overloading
To access this page, click Management > LLDP > LLDP Overloading.
Figure 4.86 Management > LLDP > LLDP Overloading
The ensuing table for LLDP Overloading settings are informational only: Port, Total
(Bytes), Left to Send (Bytes), Status and Status (Mandatory TLVs, 802.3 TLVs,
Optional TLVs and 802.1 TLVs).
4.9.2 SNMP
Simple Network Management Protocol (SNMP) is a protocol to facilitate the monitor-
ing and exchange of management information between network devices. Through
SNMP, the health of the network or status of a particular device can be determined.
4.9.2.1 SNMP Settings
The SNMP Settings page allows you to set the SNMP daemon state (enabled or dis-
abled).
To access this page, click Management > SNMP > SNMP Settings.
Figure 4.87 Management > SNMP > SNMP Settings
The following table describes the items in the previous figure.
The ensuing table for SNMP Information settings are informational only: SNMP.
Item Description
State Click Enabled or Disabled to define the SNMP daemon.
Apply Click Apply to save the values and update the screen.