EKI-7710 Series User Manual 95
The following table describes the items in the previous figure.
The ensuing table for User Status settings are informational only: User Name,
Access Right, Auth-Protocol, Priv-Protocol and Delete (click to delete the desired
user name).
4.9.2.4 SNMP Trap
The SNMP Trap page allows you to set the IP address of the node and the SNMP
credentials corresponding to the version that is included in the trap message.
To access this page, click Management > SNMP > SNMP Trap.
Figure 4.90 Management > SNMP > SNMP Trap
The following table describes the items in the previous figure.
The ensuing table for Trap Host Status settings are informational only: No., IP
Address, Community Name, Version and Delete (click to delete the desired IP
address).
Item Description
User Name Enter a user name (up to 32 characters) to create an SNMP profile.
Access Right Click read-only or read-write to define the access right for the profile.
Encrypted Click the option to set the encrypted option for the user setting.
Auth-Protocol Click the drop-down menu to select the authentication level: MD5 or
SHA. The field requires a user password.
MD5: specify HMAC-MD5-96 authentication level
SHA: specify HMAC-SHA authentication protocol
Password Enter the characters to define the password associated with the
authentication protocol.
Priv-Protocol Click the drop-down menu to select an authorization protocol: none or
DES.The field requires a user password.
None: no authorization protocol in use
DES: specify 56-bit encryption in use
Password Enter the characters to define the password associated with the
authorization protocol.
Add Click Add to save the values and update the screen.
Item Description
IP Address Enter the IP address to designate the SNMP trap host.
Community Name Click the drop-down menu to select a defined community name.
Version Click the drop-down menu to designate the SNMP version credentials
(v1 or v2c).
Add Click Add to save the values and update the screen.
To Next Page
Loading...
Need help?
General
