Advantech EKI-7710E-2C User Manual

42 EKI-7710 Series User Manual
4.4.3 DHCP Auto Provision
The DHCP Auto Provision feature allows you to load configurations using a server
with DHCP options. Through the remote connection, the switch obtains information
from a configuration file available through the TFTP server.
To access this page, click System > DHCP Auto Provision.
Figure 4.11 System > DHCP Auto Provision
The following table describes the items in the previous figure.
The ensuing table for DHCP Auto Provision Information settings are informational
only: Status.
4.4.4 IPv6 Settings
To access this page, click System > IPv6 Settings.
Figure 4.12 System > IPv6 Settings
The following table describes the items in the previous figure.
The ensuing table for IPv6 Information settings are informational only: Auto Config-
uration, IPv6 In Use Address, IPv6 In Use Router, IPv6 Static Address, IPv6 Static
Router and DHCPv6 Client.
Item Description
Status Select the radio button to enable or disable the DHCP Auto Provision-
ing Setting.
Apply Click Apply to save the values and update the screen.
Item Description
Auto Configuration Select the radio button to enable or disable the IPv6.
IPv6 Address Enter the IPv6 address for the system.
Gateway Enter the gateway address for the system.
DHCPv6 Client Enter the DHCPv6 address for the system.
Apply Click Apply to save the values and update the screen.

Advantech EKI-7710E-2C Specifications

General

Brand	Advantech
Model	EKI-7710E-2C
Category	Switch
Language	English